View Job Openings

Concrete Finisher

Description:Smooth and finish surfaces of poured concrete, such as floors, walks, sidewalks, roads, or curbs using a variety of hand and power tools. Align forms for sidewalks, curbs, or gutters; patch voids; and use saws to cut expansion joints. Must have forming experience.

Set the forms that hold concrete to the desired pitch and depth and align them.
Position construction forms or molds.
Check the forms that hold the concrete to see that they are properly constructed.
Inspect completed work to ensure proper installation.
Spread, level, and smooth concrete, using rake, shovel, hand or power trowel, hand or power screed, and float.
Spread concrete or other aggregate mixtures.
Finish concrete surfaces.
Monitor how the wind, heat, or cold affect the curing of the concrete throughout the entire process.
Monitor construction operations.
Direct the casting of the concrete and supervise laborers who use shovels or special tools to spread it.
Direct construction or extraction personnel.
Produce rough concrete surface, using broom.
Finish concrete surfaces.
Mold expansion joints and edges, using edging tools, jointers, and straightedge.
Finish concrete surfaces.
Clean chipped area, using wire brush, and feel and observe surface to determine if it is rough or uneven.
Clean surfaces in preparation for work activities.
Signal truck driver to position truck to facilitate pouring concrete and move chute to direct concrete on forms.
Pour materials into or on designated areas.
Signal equipment operators to indicate proper equipment positioning.
Apply hardening and sealing compounds to cure surface of concrete, and waterproof or restore surface.
Finish concrete surfaces.
Apply sealants or other protective coatings.
Operate power vibrator to compact concrete.
Compact materials to create level bases.
Chip, scrape, and grind high spots, ridges, and rough projections to finish concrete, using pneumatic chisels, power grinders, or hand tools.
Smooth surfaces with abrasive materials or tools.
Cut out damaged areas, drill holes for reinforcing rods, and position reinforcing rods to repair concrete, using power saw and drill.
Drill holes in construction materials.
Position structural components.
Break up rock, asphalt, or concrete.
Waterproof or restore concrete surfaces, using appropriate compounds.
Apply sealants or other protective coatings.
Cut metal division strips and press them into terrazzo base so that top edges form desired design or pattern.
Cut metal components for installation.
Apply decorative masonry finishes.
Wet concrete surface and rub with stone to smooth surface and obtain specified finish.
Finish concrete surfaces.
Wet surface to prepare for bonding, fill holes and cracks with grout or slurry, and smooth, using trowel.
Prepare surfaces for finishing.
Install masonry materials.
Apply material to fill gaps in surfaces.
Install anchor bolts, steel plates, door sills and other fixtures in freshly poured concrete or pattern or stamp the surface to provide a decorative finish.
Finish concrete surfaces.
Install metal structural components.
Install building fixtures.
Fabricate concrete beams, columns, and panels.
Install masonry materials.
Fabricate parts or components.

Full-Time /40+ hours a week
Day starts typically at 6am.
Shift ends typically at 5pm
Saturday/Sunday work as required

If interested, please send your resume to for consideration.
Category: Construction
Location:Duncan, SC
Apply Here: